dsw
regular
Reged: 22/04/2007
Posts: 173
Loc: kent
|
|
how much shaft should be showing from the back of the boss to the end of the stern tube ?
|
eyehavit
regular
Reged: 16/02/2005
Posts: 213
|
|
My rule of thumb for conventional drive shafts is preferably:
(1) Not more than shaft diameter x 1
(2) Not less than amount of forward axial movement + 2mm
|
Tranona
regular
Reged: 10/11/2007
Posts: 792
|
|
Thats only a rule of thumb. There is often more. The "norm" is about 15mm to allow water to flow in and out of the tube. Less may cause problems with cutless not getting enough water. If you fit a rope cutter the gap has to be around 40mm on a 25mm shaft - well above the 1 x shaft diameter "rule" and causes no problems.
Is your question because you have a large or small amount showing?
|
eyehavit
regular
Reged: 16/02/2005
Posts: 213
|
|
Are you asking me or dsw?
|
Bilgediver
regular
Reged: 06/06/2001
Posts: 1220
Loc: Scotland
|
|
(1) Not more than shaft diameter x 1
(2) Not less than amount of forward axial movement + 2mm
***************************************************
I would suggest in some circumstances these do not work out as the best solution.
There needs to be adequate gap between the propeller and cutless bearing for a free flow of water to flood and circulate in the bearing and I feel 2mm does not meet this requirement. In fact one only has to do an eyball survey around a marina to see that most folk agree with me and it seems that a normal gap is around 2/3D on a 1" shaft .
If the propeller sits inside a cut out then this also may be a determining factor
--------------------
Eastern Scotland and beyond.
|
dsw
regular
Reged: 22/04/2007
Posts: 173
Loc: kent
|
|
i have no shaft showing at all but there is plenty of adjustment so to let the shaft slide back and the shaft is 48mm and the prop is 27x16 stern tube is flush with the steel hull.
|
Tranona
regular
Reged: 10/11/2007
Posts: 792
|
|
Following the previous posts, if you have a conventional water lubricated cutless bearing then you need a gap to let the water out - 15/20mm. You may on the other hand have an oil or grease filled tube with a seal on the outboard end in which case you do not need a gap.
|
eyehavit
regular
Reged: 16/02/2005
Posts: 213
|
|
"You may on the other hand have an oil or grease filled tube with a seal on the outboard end in which case you do not need a gap. "
As long as there is zero axial movement, assuming his engine is solid mounted as opposed to elastomer mounts.
Elastomer mounted engines under full load can move as much as 9mm.
|
eyehavit
regular
Reged: 16/02/2005
Posts: 213
|
|
To any "Rule of thumb" there will always be exceptions dependant on individual circumstances. That is why I said "Preferably".
I dislike grossly extended shafts as they place undue stress on the aftmost prop shaft bearing.
|
Tranona
regular
Reged: 10/11/2007
Posts: 792
|
|
Will be interested in DSW reply. Unlikely that the engine will be solidly mounted. More likely to be flexibly mounted but with flexible coupling and thrust bearing such as an Aquadrive or similar. This allows the shaft to be effectively fixed with no fore and aft or axial movement. An oil filled tube with lip seals such as used on ships can then be used. Have seen this kind of arrangement in Dutch steel boats.
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
