Aeolus
regular
Reged: 03/08/2004
Posts: 171
Loc: Sussex
|
|
I've just been quoted ~£140 plus VAT per shroud/forestay/backstay for new standing rigging. This excludes fitting.
Does that sound expensive? It's for a 29 foot masthead sloop.
--------------------
Jonathan / Aeolus
|
srp
regular
Reged: 10/05/2006
Posts: 1106
Loc: IoW
|
|
Depends on the fittings you have specified on the ends, and whether you want new bottlescrews. The rigging wire itself is quite cheap (about £1 a metre for 4mm), but a swaged terminal would cost around £16 each end - this according to the last bill I had from Spencers Rigging in February.
--------------------
www.corribee.org
|
tiggertoo
regular
Reged: 23/08/2005
Posts: 1158
Loc: UK
|
|
Sounds good to me. But what does that include?
|
Aeolus
regular
Reged: 03/08/2004
Posts: 171
Loc: Sussex
|
|
Just to clarify - that's £140 plus VAT for each shroud, not including new bottlescrews and not including fitting.
If swaged terminals are £16 each and 6mm wire is around £3 per metre, then a 12 metre long shroud should cost £16 x 2 + £3 x 12 which works out at £68. I'm being charged double that. Or is my calculation flawed?
--------------------
Jonathan / Aeolus
|
Peegee
regular
Reged: 11/06/2001
Posts: 49
Loc: Kent
|
|
I took all mine off(mast already down) and took it along to a local firm in Sittingbourne Kent. All done with new bottle screws,swaged terminals,and they even supplied the split-pins. under £300 the lot for 27'masthead rig
|
John_Wilson
regular
Reged: 22/07/2006
Posts: 350
|
|
Sounds expensive. Most riggers now use bottlescrews that have one end that swages on to the wire, so each shroud has one swage and one bottlescrew included.
|
calypso1
regular
Reged: 04/12/2007
Posts: 95
Loc: brightlingsea essex
|
|
Cost me £400 for split backstay, forstay, shrouds and fore and aft lowers and new bottle screws all round.26 foot sloop.
|
SloppyJoe
regular
Reged: 04/06/2001
Posts: 2623
|
|
Try a quote from Jimmy Green. I was very surprised at his prices when I re-rigged last October. Service and supply time was excellent too.
|
30boat
regular
Reged: 26/10/2001
Posts: 801
Loc: Portugal
|
|
Very expensive.
I've been quoted £103 for each cap for my Fulmar and that's in 7mm Dyform. By ZSpars by the way.
|
alldownwind
regular
Reged: 10/08/2004
Posts: 1229
Loc: Swale
|
|
Quote:
I took all mine off(mast already down) and took it along to a local firm in Sittingbourne Kent. All done with new bottle screws,swaged terminals,and they even supplied the split-pins. under £300 the lot for 27'masthead rig
PeeGee, what firm was that in Sittingbourne, please?
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
