Fitting Backflap hinges

[fergie_mac66]

you dont need back flaps you need counter tops or bar tops ..still need cutting in tho

http://www.handles4doors.co.uk/produ...5316&CatID=659

[Roach1948]

thanks a lot - will get started

[nortonmotors]

When building my chart table, I used two flap hinges so that it would lift over-centre and stay open.
The attached photo shows them inset into the table ; careful chiselling is needed around the dovetails

[Amulet]

I used these.

This is my practice attempt at fitting them.